I Overengineered a Spinning Top
Aaed Musa, an engineering creator at an unstated company, explains how he designed and tested a self-contained electric spinning top; no guest or location is stated.
Aaed Musa, a robotics builder, explains how he designed and tested a compact internal cycloidal actuator, drawing on MIT’s Mini Cheetah and his earlier Eagle Power actuator.
Musa models the actuator on the MIT Mini Cheetah’s motor-centered gearbox, but chooses a cycloidal drive. He describes a quasi-direct-drive motor with 40 poles and 36 slots, then changes to a 100 mm stator after his first winding proved too small. The final stator uses six strands of 26-gauge wire, with six turns per slot.
The gearbox uses an eccentric shaft to move a cycloidal disc against a fixed ring of roller pins; eight disc lobes and nine pins produce an 8:1 reduction. A second disc positioned 180 degrees out of phase counterbalances the rotating assembly. Musa says the disc remains in contact with the pins, which can reduce backlash, and that the prototype fit inside the stator and was back-drivable.
Musa has the rotor and gearbox ring machined from 1045 steel and 6061 aluminum, then assembles them with the wound stator and N52 magnets. The motor runs in a test setup and measures 104 KV, close to the Eagle Power motor’s experimental 108 KV. An ODrive S1 controller provides position, velocity, and torque control.
Heat warped the plastic housing during testing, shifting the rotor off-center; Musa also found that he had omitted lubricant. The actuator measures about 125 mm in diameter, 84 mm long, and 1.23 kg, with a top speed near 209 RPM at 22.2 volts and peak torque of about 16.17 N·m. It is roughly 0.9 inches shorter than his Eagle Power planetary actuator, but cost nearly $400 and had more backlash than expected.
Briefs summarise talks and interviews; timestamps open the video at that moment. Claims in a talk are the speaker's own.
Aaed Musa, an engineering creator at an unstated company, explains how he designed and tested a self-contained electric spinning top; no guest or location is stated.
Aaed Musa, a robotics builder, explains how he designed, assembled, programmed, and tested Topps, a custom quadrupedal robot dog.